Siemens 5WG1524-4DB23, RL 524D23

SIEMENS

$129.30

For control of drives with a DC motor for DC 24 V
Two relays per output for polarity switching of the output voltage
Rated contact operating voltage DC 24 V
Rated contact current: 6 A
Electronics for detection of the actuation of an electromechanical and electronic limit switches
Automatic travel time determination via current detection
Maintenance-free terminals for connection and through-wiring of untreated single-core, stranded or multi-core conductors, 0.5 ... 2.5 mm²
Two terminals per actuator channel for motor connection (up, down)
Two terminals on the device to connect the DC 24 V (+/-) to supply the load circuits
Bus-powered electronics
Housing: plastic
As built-in device for mounting in a separately to be ordered Control Module Box AP 118
Type of protection: IP 20

Additional functionalities GAMMA

Selectable operation mode blinds, shutter/awning, ventilation flap
Per actuator channel motion commands for moving and stopping the solar protection or for adjustment of blind slats
Per actuator channel direct movement to a position of the sunblind and the blind slats
Per actuator channel central movement of the solar protection in manual mode and automatic mode and delay time for Up / Down
Distinction between automatic and manual mode (position of the sunblind and blind slats) and adjustable behaviour in sunshine
Programming and recalling preset positions 1-4 and 8-bit scene control
Adjustable behaviour in case of override (wind, rain, frost, lock, forced position, forced control, range limitation)
Adjustable reverse pause time and delay times of the drives
Per actuator channel configurable state on bus voltage failure and start value on bus voltage recovery
Adjustable transmission of status objects (automatic operation, curtain and slat position, travel, calibration travel time to end positions, overriding) on request, cyclically and/or upon change
Adjustable transmission time of the status objects after bus voltage recovery and transmission delay between the status objects
Surveillance of device function

Additional info

The automation module box AP 118 must be ordered separately.See chapter Modular installation system, Room automation box - Housing.